Which part is letting the toilet run?
Two common failures look similar from the hallway: the toilet runs, or the bowl ripples. A dye test helps you tell them apart. If color shows up in the bowl after 10 minutes without a flush, the tank seal is a likely path. If water flows into the overflow tube, check the fill valve or the float height.
Updated .
Start with the 10-minute dye test. If several fixtures back up, see the clogged drain page. Moisture on windows is covered under condensation.
At a glance
| Symptom | Likely first check |
|---|---|
| Dye in the bowl after 10 minutes | Flapper or flush-valve seat |
| Water flowing into the overflow tube | Fill valve or float height |
| Both symptoms | Fix fill height first, then retest |
Two common failures look similar from the hallway: the toilet runs, or the water in the bowl ripples. A dye test helps you tell them apart. If color shows up in the bowl after 10 minutes without a flush, the seal at the bottom of the tank (the flapper or flush-valve seat) is a likely path. If you lift the lid and see water flowing into the overflow tube, the fill valve is not shutting off, or the float is set too high.
- A worn, warped, or dirty flapper often needs replacement with a size that matches the drain opening. The tank model is often printed inside the lid or at the back wall of the tank.
- A fill valve that never stops may need a water-level adjustment or a replacement valve. Do not bend parts that are not meant to be bent.
- If both symptoms are present, fix the fill height first so the tank is not overflowing, then repeat the dye test.
When to stop and call a professional
Call a licensed plumber if the tank or bowl is cracked, if parts are corroded or stuck, if you cannot shut the water off, or if a straightforward parts swap does not stop the leak. This page is a first check, not a full repair manual.
Sources
Common questions
How can I tell a bad flapper from a fill-valve problem?
If dye appears in the bowl after 10 minutes without a flush, the flapper or flush-valve seat is a likely path. If water flows into the overflow tube, look at the fill valve or the float height.
What if both symptoms are present?
Fix the fill height first so the tank is not overflowing, then repeat the dye test.
Where do I find the tank model for a replacement part?
The tank model is often printed inside the lid or at the back wall of the tank. Use a flapper size that matches the drain opening.
When is this no longer a first check?
Call a licensed plumber if the tank or bowl is cracked, parts are corroded or stuck, you cannot shut the water off, or a straightforward parts swap does not stop the leak.